I think my problem was caused by the fact that on my shard you don't spawn right on top of the gate but like 2-3 tiles away from it so in order to use only 1 rail for all the movement i had to mark a spot on both sides of the gate and then sometimes my character ran back into the gate causing it to get lost. Now what i did was to modify the script to support different rail for each way and now the script runs perfectly (or has ran for like 48 hours straight ;p)

Here's the rude method i used to hardcode my little rail into it. Uses a new rail i made with the railengine.

Well i thought it was enough to include everyone who's contributions i used in the disclaimer but now i sent a pm to Crome, hopefully hes ok with this.

Originally posted by Crome, i decided to modify it to satisfy my needs. Basically it's the same script with some subs to enchance the performance and to add cLAW support (well actually its enforced, will get caught in a loop if you don't have cLAW running.) Have bolts in your inventory and start the harp quest simple bow on the other bowcrafter npc, then run this script to cycle quests on the another. I suggest standing near the trash barrel and using it for trash bag.

Doesn't really contain OCR, reads only a single pixel from the gump. You might need to change the location of the pixel depending on the shard.

I might give some limited support for this script but this was really a temporary thing for me as i intend to play around with the HWQ 1.29.

Thanks go out for TrailMyx and everyone who's subs i used (from HWQ), and to Crome for the original script

I think i got it, i marked the recall rune just 2 tiles from the gate in Yew and now it has been up and running for about 4 hours. I did mess around with the rail a bit too, not truly sure what fixed it but imo the destination matters more than the trip, huh? ;p

Hope you don't mind if i try to get it to turn in bolts too, would be faster to stock some bolts along with boards and do both quests. Will post it here ofc if i get anything useful out of my experiments..

Too bad that isn't possible, it would had been easy to fix this situation. I'll try to play around with the rail a little more, as it seems that's whats causing the issue.

Weirdest thing is that it does succesfully restock sometimes (ofc when i'm on the computer and able to see whats going on).

One more problem! Seems like the script keeps pulling more and more ingots until i'm overweight and start dropping the items manufactured. Couldn't really find a function reading the backpack weight, how is it done in this script? It seems to look for property but couldn't comprehend it fully. :/

I'm on a FS which is running on runuo and has ML & SE but not SA.

Have to say the method you use to store the craftinfo's for items is pretty innovative. Really took me a while to figure it out. Doesn't currently work in my fs because of gumpsizes (just like timbo's didn't) but will work it out when my ADHD level is a little lower. Thanks for the script!

Pretty amazing script i'd say! Doesn't currently work on my fs because of gumpsizes and buttons in odd order but by my sword i swear i will fix it.  10/10 i'd bang