I'm just looking for ideas. I have the basic script written. It will allow you to setup and save any number of rails to farming spots. Even inside caves/dungeons. Then when it gets to the spot, it will farm. When it's killed a set number of spawn type that you select, it leaves, and recalls to the next spot. You just have to match the runes with the spot in the list. Atm, the max is set to the max amount of runes in a book. And the rail spots are interchangeable, so you can move them up and down the list, just in case your runes dont match, you don't have to change your book around, you just move the rail up or down to match the runebook. And you can use atm either a mage or a sammy with it. It has bank support, and checks weight, will rail out, bank, recall back, continue to farm until amount of specific monster type is killed. Just looking for good ideas to flesh it out. I was thinking rail spot "action" buttons. Like farm multiple rail points. Rail offshoots? So you rail into a dungeon, create a rail, then create a rail "offshoot" that you can assign loop values to. So if you run the rail twice, it will go down the offshoot once. Just use your imagination and imagine good ideas. That's what I'm lookin for.
